本帖最後由 dtom 於 2016-8-16 22:47 編輯
第一次印 0.1 結果 
改少收鼻水後
無用 support 有啲位都係差啲啲, 但用左我怕仲花
入面啲鼻水好似千年古洞咁就無謂影啦
有師兄話低5度再慢啲印, 應該就靚靚
Slicer : KISSlicer v1.5 Bata 3.10
Printer Gcode - Prefix:- ;Start GCode
- G21 ;metric values
- G90 ;absolute positioning
- M82 ;set extruder to absolute mode
- M107 ;start with the fan off
- G28 X0 Y0 ;move X/Y to min endstops
- G28 Z0 ;move Z to min endstops
- G1 Z50.0 F3750 ;move the platform down 50mm
- G1 Z2 X-64 Y58 F9000 ;move the platform close the printbad
- M109 S205 ;Set Extruder Temperature and Wait
- G92 E0 ;zero the extruded length
- G1 F200 E15 ;extrude 15mm of feed stock
- G1 Z2.6 X-64 Y58 F9000 ;move the platform up 2.6mm
- G92 E0 ;zero the extruded length again
- M117 Printing... ;Put printing message on LCD screen
- ;End GCode
- M104 S0 ;extruder heater off
- G91 ;relative positioning
- G1 E-9 F6000 ;retract the filament a bit before lifting the nozzle, to release some of the pressure
- G28 Z223 F3000 ;move to home
- M84 ;steppers off
- G90 ;absolute positioning
|
簡體版
訂閱頻道
訂閱電子報
發表於 2016-8-16 17:55
| 
發表於 2016-8-16 19:58
| 
