CWPP

原帖由 Exai 於 2009-6-29 14:48 發表
今次主要5係為樣
只係為溫度

為溫度?
forgot to put two extract fans on the rear radiator?

CWPP

alum (anodised) + copper in same loop, I assume you have a good strong protective coolant then, however strong coolant has conflict with water blocks having acrylic top especially when in operation/tension.... screw threads is made on the acrylic top side.

I still like your RAM block very much although it runs smaller tubes. It is such a representable classic

[ 本帖最後由 CWPP 於 2009-6-30 02:28 編輯 ]

amoslee

原帖由 hamsterspeed 於 2009-6-29 15:17 發表


我經驗話我知 如果你條loop起泡起成咁 就算過多幾日都會係一樣...
我開頭第一次玩就係好似你咁成條loop起泡起到變白...
正常排泡係應該10-15分鐘完成

哈! 喱個問题咪早幾日討論過囉....?

Exai

今次上水主要都係令4890降下溫

hamsterspeed

原帖由 amoslee 於 2009-6-29 15:36 發表

哈! 喱個問题咪早幾日討論過囉....?

係... 不過唔緊要啦 樓主應該新黎 大家提點下佢仲好 唔係自己整錯野都唔知

係epc出post 好玩之處 就係會成日比人critic
我地又係小玩意中尋找大學問攞

[ 本帖最後由 hamsterspeed 於 2009-6-29 16:00 編輯 ]

hamsterspeed

原帖由 Exai 於 2009-6-29 15:52 發表
今次上水主要都係令4890降下溫

guys case closed

CWPP

原帖由 hamsterspeed 於 2009-6-29 15:56 發表


係... 不過唔緊要啦 樓主應該新黎 大家提點下佢仲好 唔係自己整錯野都唔知

係epc出post 好玩之處 就係會成日比人critic
我地咪又係小玩意中尋找大學問攞

Hey, HampsterS hing, it is an interesting case which the reservoir is in the middle of loop, but not before the pump as in usual setup. If those are really bubbles, it reflects either the pump is really powerful or the reservoir can generate much bubbles.

Most importantly, I cannot be sure if they are true colour of coolant or bubbles. The system/pump may be not even running in the picture, fans are not running......

[ 本帖最後由 CWPP 於 2009-6-29 16:12 編輯 ]

hamsterspeed

I pretty sure the coolant should be in green check the res on 2nd pic. I think the problem comes from the res.

[ 本帖最後由 hamsterspeed 於 2009-6-29 16:17 編輯 ]

CWPP

原帖由 hamsterspeed 於 2009-6-29 16:17 發表
I pretty sure the coolant should be in green check the res on 2nd pic. I think the problem comes from the res.

Yes, but I think the water coolant in the loop is idle, system is not running, coolant is in cream colour, so I think they are totally 2 different stages/setup photos rather. The photo particularly shows the reservoir with green water is out of place, maybe it is a seperate poster just to introduce the model of reservoir, the photo name DSC046.jpg is another hint comparing with others. This is becoming  an photohunt exercise, I better stop.....

[ 本帖最後由 CWPP 於 2009-6-29 16:36 編輯 ]

amoslee

原帖由 CWPP 於 2009-6-29 16:06 發表


Hey, HampsterS hing, it is an interesting case which the reservoir is in the middle of loop, but not before the pump as in usual setup. If those are really bubbles, it reflects either the pump is re ...

樓主可否提供水道以供参考? thx!
諝問是否有用並聯的水道?