[操作疑難] 神奇的Cura切片一问？

teamling

小弟用Cura4.4在热床为225x225x50mm上排放整版零件（大概90个零件）时切片切左成晚9个钟都未切完。但又吾系死机。试过2台i7电脑切片都系甘。吾知有冇ching遇上同样ge情况呢？（我发觉单切一个小零件Cura4.4切比S3D慢好多，S3D要2秒而Cura4.4要成10秒）

仲有就系我用的是双独立喷头打印机，升级到Cura4.8就找不到在Cura4.4上的双头打印机型号，所以上面呢个问题不能转用Cura4.8尝试解决。请问各位ching有无办法把Cura4.4上的打印机driver文件copy入Cura4.8里揾到部双头打印机吗？

xo_ox

小弟用Cura4.4在热床为225x225x50mm上排放整版零件（大概90个零件）时切片切左成晚9个钟都未切完。但又吾系 ...
teamling 發表於 2021-5-16 10:49

   
I only found the gcode file from Cura is bigger than S3D ...
I have the same problem , still un-solve ...

teamling

I only found the gcode file from Cura is bigger than S3D ...
I have the same problem , still ...
xo_ox 發表於 2021-5-16 11:18

係ra，吾知点解决好！